Manual Version 41859.10 at 2008/05/23 18:09:36
For suggestions regarding this manual contact: docs@4psa.com
Copyright © 2002-2008 Rack-Soft, LLC
All rights reserved.
Distribution of this work or derivative of this work is prohibited unless prior written permission is obtained from the copyright holder.
VoipNow is a Registered Trademark of Rack-Soft, LLC.
4PSA is a Registered Trademark of Rack-Soft, LLC.
Asterisk is a Trademark of Digium, Inc.
Linux is a Registered Trademark of Linus Torvalds.
All other trademarks and copyrights are property of their respective owners.
Table of Contents
35 minutes
|
| It will take about 35 minutes to an intermediate user to read this document and follow the steps highlighted here. |
-
Download the 4PSA VoipNow ISO image from http://download1.4psa.com/voipnow/voipnow.iso. The 4PSA VoipNow ISO image is based on CentOS 5.1 operating system.
-
Burn the ISO image on a CD using your favorite burner software.
-
Insert the CD in your computer. It is STRONGLY recommended to use a dedicated computer for this purpose, even if you install 4PSA VoipNow only for a demo. The computer hard drive might be totally repartitioned during the installation (based on your selection).
-
Boot from 4PSA VoipNow CD.
-
Press
<ENTER>when the boot prompt appears if you want to manually partition your hard drive or write autopartition and press<ENTER>if you want the installer to automatically partition your hard drive (WARNING: THIS WILL ERASE YOUR HARD DRIVE). -
Follow the installer instructions and set the timezone and root password.
-
The installer will reboot the system and the installed 4PSA VoipNow distribution will boot. You will be asked to setup the IP address, network mask and network gateway. Make sure that you enter correct settings, otherwise you will not be able to access the server.
To setup a nameserver you have to perform the following command after you log in
echo "nameserver <dns_server_ip>" >> /etc/resolv.conf -
Go to another computer and point your browser to:
https://<server_ip>Where
<server_ip>is the IP of the server you installed 4PSA VoipNow on. -
The 4PSA VoipNow login screen appears. You can login as the system administrator using:
Username:
adminPassword:
welcome -
You can start with the initial configuration steps. Enjoy 4PSA VoipNow!
Do not forget to check the:
- Product documentation at http://www.4psa.com/docs/voipnow/
- Command line installation instructions at http://www.4psa.com/docs/voipnow/voipnow_commandline_installation.html (these will be necessary if you need to update the system in the future)
Development office:
| Rack-Soft SRL |
| DCL Office Building, 20-22 Bilciuresti Street, sector 1 |
| Bucharest, 014012 |
| ROMANIA |
| Phone: 646-957-8997 (US), 021-3130165 (Romania) |
| Fax: 270-638-0988 (US), 021-3130165 (Romania) |
E-mail:
- For purchasing and sales information, email sales@4psa.com
- For partnership opportunities, email channel@4psa.com
- For translations and localization, email docs@4psa.com