4PSA DNS Manager 4.0.0
ISO Image Installation Instructions

Manual Version 77835.3 at 2011/03/07 15:05:51

For suggestions regarding this manual contact: docs@4psa.com

All rights reserved.

Distribution of this work or derivative of this work is prohibited unless prior written permission is obtained from the copyright holder.

DNS Manager is a registered trademark of 4PSA (Rack-Soft, Inc.).

Linux is a registered trademark of Linus Torvalds.

All other trademarks and copyrights are property of their respective owners.

Table of Contents

Installation Steps
Important
Contact and Support
35 minutes
It will take about 35 minutes to an intermediate user to read this document and follow the steps highlighted here.

Installation Steps

  1. Download the 4PSA DNS Manager ISO image from http://download1.4psa.com/dnsmanager/dnsmanager.iso. The 4PSA DNS Manager ISO image is based on CentOS 5.4 operating system.

  2. Burn the ISO image on a CD using your favorite burner software.

  3. Insert the CD in your computer. It is STRONGLY recommended to use a dedicated computer for this purpose, even if you install 4PSA DNS Manager only for a demo. The computer hard drive might be totally repartitioned during the installation (based on your selection).

  4. Boot from the 4PSA DNS Manager CD.

  5. Press <ENTER> when the boot prompt appears if you want to manually partition your hard drive or write autopartition and press <ENTER> if you want the installer to automatically partition your hard drive (WARNING: THIS WILL ERASE YOUR HARD DRIVE).

  6. Follow the installer instructions and set the timezone and root password.

  7. The installer will reboot the system and the installed DNS Manager distribution will boot. You will be asked to setup the IP address, network mask and network gateway. Make sure that you enter correct settings, otherwise you will not be able to access the server.

  8. Go to another computer and point your browser to:

    https://<server_ip>:8550

    Where <server_ip> is the IP of the server you installed 4PSA DNS Manager on.

  9. The 4PSA DNS Manager login screen appears. You can login as the system administrator using:

    Username: admin

    Password: welcome

  10. You can start with the initial configuration steps. Enjoy 4PSA DNS Manager!

Important

Do not forget to check the supplementary documentation:

Contact and Support

For online help and support please visit:

For mailing addresses and phone numbers from our offices:

http://www.4psa.com/contactus

If you have any question, do not hesitate to contact us.